With this simple guide, you too can customize your trainers with some app-controlled LEDs.

If the video player is not working, you can watch the video from this alternative link.

Fancy upgrading your Nike trainers with some Internet of Things (IoT) controlled LED lights? Then follow this simple guide to find out how. 

Source: Newsflare

As you can imagine, you’ll need some tools and materials before you get started.

Materials and gear needed

With all your gear in hand, it is time to get on with this great little build.

Step 1: Prepare your trainers

The first step is to choose, or buy, a pair of Nike trainers ready for modifying. Once in hand, remove the laces from the trainers.

With that done, take a sharp crafting knife, and carefully cut away the stitching for the side Nike logo piece of leather. 

Source: Newsflare

Take care not to unduly damage the main body of the shoe when doing so. Keep going until you can completely free the logo piece of leather. 

With that done, remove the cushioning from the bottom of the trainer too. Next, take your crafting knife once again, and carefully cut the stitching for the inside sole of the shoe too. 

Once done, gently peel back the covering of the “walls” of the inside of the shoe. Next, take your crafting knife once again, and carefully cut out the part of the shoe directly behind the Nike logo you previously removed. 

Source: Newsflare

Step 2: 

Next, take the removed Nike logo and trace it around it on a piece of translucent plastic. Cut it out using a pair of scissors as needed.

With that done, drill a series of holes to match the stitching on the original logo. Next, stitch the plastic to the Nike trainer as needed using a needle and thread.

Make sure the stitching is strong as it will need to sustain long-term wear and tear. 

Source: Newsflare

Step 3: Build the electronics

With that done, take your E10 Wi-Fi access point dongle, and strip off its casing. Next, remove the circuit board within, and remove the power cable. 

With that done, take a battery and connect a small switch to one of the terminal wires. Solder the terminal wires from the battery to the E10 Wi-Fi Access point circuit board as needed. 

Source: Newsflare

With that done, connect your LED strip light to the circuit board matching terminals. The strip light should immediately light up. 

Source: Newsflare

Step 4: Install the lights into the trainer

With that done, take your Nike trainer and cut out a small section of the rubber cushioning at the bottom of the shoe. The hole will need to be large enough to house the battery. 

Source: Newsflare

With that done, wedge the battery into the hole at the bottom of the shoe as needed. Then glue the LED strip light behind the plastic logo you stitched into place earlier. 

<p …….

Source: https://interestingengineering.com/video/nike-trainers-customized-led-lights